Bendix Commercial Vehicle Systems VORAD VS-400 SYSTEM INSTALL GUIDE - Manual (Page 3)

General Information
2
Warnings and Cautions
▲
WARNING
!
▲
WARNING
!
Improper use of this system could lead to a serious accident. Read this entire Installation Guide before operating the Bendix ™
VORAD ® VS-400 system. Pay particular attention to the safety messages below. This manual should be used in conjunction with
proper training.
Limitations of Collision Warning Systems
The Bendix ™ VORAD ® VS-400 collision warning system is intended solely as an aid for an alert and conscientious professional driver.
It is not to be used or relied upon to operate a vehicle. The system should be used in conjunction with rear view mirrors and other
instrumentation to maintain safe operation of the vehicle, ground personnel, and adjacent property. A vehicle equipped with the Bendix
™
VORAD ® VS-400 system should be operated in the same safe manner as if the system were not installed. The system is not a substitute
for normal safe driving procedures. It will not compensate for any driver impairment, such as drugs, alcohol, or fatigue. Should the system
become inoperative, it could jeopardize the safety or lives of those who depend on the system for safety.
The system will not sense objects if the sensor view is obstructed. Therefore, do not place objects in front of the system sensor.
Remove heavy buildups of mud, dirt, ice, and other materials.
Proper alignment is critical to correct operation of the system.
Testing and inspection of the system in accordance with these instructions and record of the results should be listed on the
daily maintenance report. The units on operating vehicles must be tested each day (see the “Testing and Maintenance” section)
prior to the vehicle’s operation. Results of this test must be recorded in the maintenance log.
People operating this equipment MUST check for proper operation at the beginning of every shift or safety inspection period.
▲
WARNING !
People’s lives depend on the proper installation of this product in conformance with these instructions. It is necessary to read,
understand, and follow all instructions shipped with the product.
Failure to follow all safety precautions and instructions may result in property damage, serious injury, or death.
The Bendix ™ VORAD ® VS-400 system is intended for commercial use. Proper installation of a backup aid requires a good
understanding of truck electrical systems and procedures, along with profi ciency in the installation.
Store these instructions in a safe place and refer to them when maintaining and/or reinstalling the product.