Bendix Commercial Vehicle Systems SMARTIRE TPMS HAND TOOL MANUAL User Manual
Page 12
Advertising
Page 12
8. After the last tire has been learned, press the down arrow. The Tool is now ready to transmit this
information to the vehicle’s tire pressure sensor receiver.
9. Using the supplied cable, connect the Tool to the diagnostic port of the tire pressure sensor
receiver. See Figure 8.
Figure 8
10. Press the check mark to begin downloading the new tire sensor IDs into the receiver.
11. If there is a communication error, the Tool displays an alert.
Check all the connections and try again.
12. If the Tool screen reverts back to the screen for entering the number of tires, then the number of
tires that was entered does not match the number of tires in the vehicle’s receiver.
Advertising