Bendix Commercial Vehicle Systems SMARTIRE TPMS HAND TOOL MANUAL - Manual (Page 7)

Page 7
Main Menu Icon Legend
ICON STATE DESCRIPTION
Handheld Battery Life
These icons indicate the battery life of the handheld device at startup.
This icon is located in the lower left area of the Tool display.
To continue, press the Check mark. To turn off the Tool and replace
the batteries, press the X.
Handheld Battery Life
This icon indicates the battery life of the handheld device.
Initiation
This icon is used to indicate initiation. When the Initiate button is
selected, this icon starts to blink during transmission.
Initiation Failure
This icon indicates Tool initiation failure. This could be caused by
either a low battery in the wheel sensor or the Tool.
Set-up Menu
This icon is used to indicate the set-up menu. When this button is
selected and held for 2 seconds the set-up menu appears. Refer to
Menu Options for more information to set-up specific options.
Learn
This icon is used to indicate sensor Learn. When the Learn button is
selected this icon starts to blink during transmission.
Main Menu Details
Initiate Function
If the Initiate button is pressed, the Tool will retrieve the sensor ID, pressure data and battery status
from the sensor that is displayed
 The button should be pressed only once to activate.
 The battery icon is used to show the battery status of the sensor.

Check icons indicates the sensor is OK.
The Wrench icon indicates the sensor is due for a change at next service.
If an error occurs, such as no information has been received, an error screen will appear. Should this
happen, retry the Initiate Function.