Specifications, Hardware specifications, Electrical specifications – Bendix Commercial Vehicle Systems SMARTIRE TPMS HAND TOOL MANUAL User Manual
Page 22: Power
Page 22
Figure 14 Sensor not found
Specifications
Hardware Specifications
General Specifications
Handheld 125 kHz LF generator.
(To provide activation of SmarTire
®
sensors)
Requires replaceable “C” cell batteries (either Alkaline or NiMH)
The battery compartment is in the rear of the unit.
Battery life expectancy is approximately 300+ activations.
A Tool battery level indicator is located in the lower left hand corner of the main display screen.
Electrical Specifications
Communication Interfaces
RS-232 (diagnostic interface port): Used for updating the Tool and for communicating with
J1939 receiver.
System Resources
100 sensor memory space.
Power
PARAMETERS
CONDITION
VALUE
Supply Voltage
(Alkaline or NiMH)
Three (3) “C” Cell
Batteries, or equivalent
NiMH rechargeable.