Bendix Commercial Vehicle Systems VORAD EVT-300 DRIVER INSTRUCTIONS - Manual (Page 14)

Driver Display Indicators
Range Control* and
Accident Recorder* When rotated from minimum to maximum*, and
not in Bendix
™ SmartCruise ® system*, this control
knob provides range adjustment of the fi rst alert
(2 to 3 seconds) and the second alert (1.75 to 2
seconds). Function may be confi gured to prevent
range adjustment control* (See Figure 5). When
the SmartCruise system is selected, rotation of the
knob, from maximum to minimum, will change the
following interval from 2.25 to 3.25 seconds. Accident
reconstruction is initiated by pushing and holding this
knob for fi ve (5) seconds, thereby freezing the most
recent event data in half of the allocated memory. (See
“In Case of an Accident” page 26). (See Figure 5)
Red, System Failure Illuminates when a problem has been detected in the
forward looking radar system. A pattern of fl ashes blink
out the faults that are stored in memory when activated
by holding in the volume control knob for fi ve seconds
(See “Diagnostic Features”, page 27). (See Figure 5)
Green, Bendix ™
SmartCruise ® */
Accident
Reconstruction*
Comes on when the SmartCruise system is enabled
and vehicle cruise control has been engaged. If
Accident Reconstruction* has been initiated to store
information, it will fl ash eight (8) times. After system
power-up and power-on LED test is completed and if
Accident Reconstruction information was previously
stored, the display will fl ash eight (8) times.
(See Figure 5)
Light Sensor Photo sensor senses ambient lighting and adjusts
intensity of the indicator lights accordingly, e.g.,
increases the brightness of the indicator lights during
daytime hours and decreases the brightness of
indicator lights at night. (See Figure 5)
10
NOTE: Items marked with an asterisk (*) can be changed (confi gured), by a
Technician, by using ServiceRanger 2.8, a PC-based service support tool.