Bendix Commercial Vehicle Systems VORAD EVT-300 DRIVER INSTRUCTIONS - Manual (Page 30)

In Case of an Accident
Accident Reconstruction Capability (Optional)
The Accident Recorder can store two segments of system data in the system’s
non-volatile memory. The fi rst of the two segments may be stored by pushing
and holding the “RANGE” knob on the Driver Display Unit for approximately fi ve
(5) seconds. Within six (6) seconds, the green “S/C” light will blink eight times,
confi rming storage of the data (see Figure 11). Subsequent pushing of the
“RANGE” knob will cause the system to respond with a “FAIL” tone. After the fi rst
segment is frozen, the second segment runs continuously recording system data
until the system is powered down.
The system’s Central Processing Unit must be returned to Bendix Commercial
Vehicle Systems to download and interpret the recorded data in the non-volatile
memory. This must be done before 30 days have elapsed, or the event will be
removed from the system memory. Before shipping the unit, contact Bendix at
1-800-247-2725. After confi rmation, ship the Central Processor Unit to Bendix,
Attn: Accident Reconstruction Specialist, 901 Cleveland Street, Elyria, OH 44035.
26
FAIL
ON S/C
Warning Level Range
Volume
Driver Identification
Card Slot
Alerts
Range Control/
Accident Recorder
Figure 11