Bully Dog 81421 Rapid Flow - Manual (Page 5)

4
4
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81421
REMOVAL OF STOCk EXHAUST SySTEM
1. Use a sawzall to cut the exhaust
immediately behind the muffler.
2. Cut the exhaust using a sawzall 4”
behind the catalytic converter.
3. Remove each piece of the stock exhaust system,
including the stock exhaust hangers. To make
removal of the hangers an easier process, it is rec-
ommended that you use a silicone spray lubricant
to spray each of the rubber hangers that hold the
stock exhaust.
Cut Exhaust Behind Muffler
Cut Exhaust directly in front of band clamp
Remove Hangers
In these steps you will remove the stock exhaust system.