Bully Dog Watchdog - Manual (Page 14)

INSTALLATION
14
part 3: run watChDOg Main wire harness
In this section you will connect the Watchdog Main Harness to the OBD ll Adaptor and then run
the other end of the main harness up the side of the vehicle dash and connect it to the back of
the Watchdog.
1. Plug one end of the Main Harness into the Main Harness port on the OBD ll adapter plug.
2. Run the other end of the harness up through the vehicle dash on the driver’s side so that the
end of the harness emerges from the dash near the vehicle A-pillar. It may be necessary to tem-
porarily remove the vehicle weather stripping and dash panel to achieve an installation where
the Main Harness cannot be seen when the driver’s door is opened.
3. Plug the Main Harness into the back side of the Watchdog, make sure that there is enough
slack in the main harness to accommodate mounting the Watchdog.
OBDII Plug
Main Cable
Power Wire
OBDII Adapter Plug Installation Diagram
Watchdog
INSTALLATION