Calculated Industries 6026 - Manual (Page 10)

10 – Scale Master ® Classic v3.0
Area and Volume
Finding Area
1) Roll the first dimension and press
[M1+]. A small “M” will appear in the
scale box display and the main display
will be cleared.
2) Roll the second dimension and press
[M2x]. The main display will be cleared.
3) Press [Rcl] [M2x]. This displays the linear
value stored in this register. The second
press of [M2x] will calculate and display
the area, which is the value stored in
[M1+] times the value stored in [M2x].
Finding Volume
1) Roll the first dimension and press [M1+].
2) Roll the second dimension and press
[M2x].
3) Storing a height value (if you have pre-
viously set a height, skip to step 4):
a. To Roll and Store a Height:
i. Roll the third dimension and
press [Subtract/Count] and [M2x]
simultaneously. The display will
show the rolled value and the unit
of measure will begin flashing.
ii. If you do not want to change the
unit of measure, go to step iii. To
change the unit of measure, press
[M1+] until you reach the desired
unit.