Calculated Industries 6026 - Manual (Page 13)

13 – User’s Guide
Error/Auto-Range Function
Error Message – Press [Reset] to clear to any
errors.
Auto Range Function – When calculating large
numbers, your answer will be displayed in the
next largest measurement unit (ex: 10,000 M
will display instead of 10,000,000 MM ).
Interference
Exposure to direct light or close proximity to cell
phones and other electronic devices may cause
interference with the Scale Master device and
result in erroneous measurements.
Automatic Shut-Off
The unit will shut itself off if it is not used for
5 minutes. Press any key to restore power. All
registers/settings remain intact.
Battery Replacement
To replace the batteries:
(1) Remove battery door;
(2) Insert batteries positive side down.
Turning the Clicker & Beep On/Off
To toggle the clicker off or on, press [Reset] and
[Scale] simultaneously. This will also toggle the
Count beep off or on.
A
PPENDIX