Calculated Industries 6026 - Manual (Page 9)

9 – User’s Guide
Rolling or Entering a Custom Scale
1) Press [Mode] until “1: CUS 1” appears
in the scale box display.
2) Press [Subtract/Count] and [Scale]
simultaneously. “ ROLL ” will appear in the
main display. If you are entering a
scale, skip to step 4.
3) Roll desired dimension. “ ROLLING “ now
appears in the main display.
Note: For greater accuracy, you may want to roll
the known distance several times, then enter
the distance times the number of rolls (for
example, roll a distance 5 times and if the
distance is 3 feet, enter 15 feet).
4) Press [Scale]. The display will show
zeroes and the units of measurement
annunciator will begin flashing (
FT
-
IN for
Imperial Mode, MM for Metric Mode).
5) If you do not want to change the units
of measure, skip to step 6. If you want
to change the units of measure, press
[M1+] until you reach the desired units.
6) Press [Scale] to begin setting the scale
distance. The left-most digit will
begin flashing. Press:
[M1+] to increment this digit,
[Subtract/Count] to decrement,
[Scale] to advance to next digit,
[Mode] to move back one digit.
7) Continue to press [Scale] until all dig-
its are set and the display returns to
zero. The scale is now stored.