Cineo Lighting TruColor LS - Manual (Page 7)

7
Accessory Attachment
The accessory attachment rails are designed to accept TruColor LS light control accessories
including louvers, egg crates, barn doors, gel frames and soft boxes. All LS accessories have
a hole that aligns with the locking mechanism at the bottom of the lamphead. To lock an
accessory, pull the lock knob on the back of the fixture while inserting the accessory. Release
when the locking pin is aligned to the hole.
Phosphor Panels
CCT for the LS fixture is changed by removing and replacing the remote phosphor panels on
the front of the lamphead.
Panels should always be inserted with the glossy side out.
Do not expose to abrasive surfaces.
Please reference the Cineo TruColor HS catalogue for available color temperature options.
To change panels, follow these steps:
1. Remove any accessories installed in the accessory slot.
2. Unthread the captive thumbscrews located on the accessory rail on both sides of the
lamphead.
3. Pull out and move accessory rails to the back of the lamphead, as shown. LEDs will
automatically shut off.
4. Remove panels and replace with panels correlating to the desired CCT, making sure that the
panels are well-seated in the retaining slot.
5. Avoid touching LEDs and the white reflective material.
6. Re-attach accessory rails.
NOTE: Please make sure that thumbscrews are securely fastened but not overly-
tightened, or fixture may not fully illuminate.