Cineo Lighting TruColor LS - Manual (Page 8)

8
Operation
After installation, attach lamphead cable between the PSU and lamphead. Do not connect
or disconnect when the PSU power is on. Maximum length of lamphead cable is 400 feet
(122m). Connect included AC power cord to PSU.
Turn on power switch; the Red indicator above the switch should illuminate. The lamphead
will turn on within two seconds. If dimming locally on the PSU, set the DMX address to
“000”. The yellow “Local” indicator lights up and all control is through the on-board dimmer.
The dimmer controls light output from 10% to 100% without color shift.
For DMX operation, select the primary DMX address on the 3-segment push-button switches.
The Green indicator will illuminate when valid DMX signal is present on the DMX Input jack.
The DMX value from 1-255 controls light output from 10% to 100.
Specifications
Input voltage: 100-240 VAC 50/60 Hz.
Power consumption: 166 watts max, 1500 watts typical
Lamp head dimensions (with yoke): 9.5”H x 11.03”W x 3.9”D
(232mm x 270mm x 96.5mm)
Lamp head weight: 4.9 lbs. (2.3 kg)
Power Supply dimensions: 4.53” H x 7” W x 15” D (115mm x 176mm x 380mm)
Power Supply weight: 12 lbs. (5.5 kg)
Head to PSU cable: 10’, 30’, 100’
Output Frequency: 0 (Direct current drive)
Beam Angle: >160°
Environmental temperature range: -20 - +50 C
Fixture temperature in-use: 55 C
IP20 Rated
35,000 hr. L70 rated
2-year parts and labor warranty
Zero UV light emitted
Made in USA