Cineo Lighting Maverick - Manual (Page 8)

8
DMX Module Operation
When the DMX module is connected to the Maverick fixture, control of the fixture is
automatically switched to the module. The DMX module has a multi-line display screen that
indicates the firmware level, control mode (local / remote) and DMX address. The module is
programmed by the use of four capacitive-touch buttons below the screen (-, +, Mode, Save).
There are two control modes: one for determining local or DMX control, and one for setting
the DMX address (0 – 255). Touching the Mode button toggles the arrow on the right of the
screen between these modes.
When the arrow is pointing to the “Control” setting, the “-” and “+” buttons will switch
between local and DMX control. When the desired control method is displayed, touch the
“Save” button to lock the setting. If the setting is not saved, it will revert to its previous
setting in a few seconds.
When the arrow is pointing to the “Address” mode, the “-” and “+” buttons will increase
or decrease the DMX address setting to the desired address. When the desired address is
displayed, touch the “Save” button to lock the setting. If the setting is not saved, it will revert
to its previous setting in a few seconds.
Disconnecting the DMX module from the Maverick fixture will place the fixture back into local
control.
Remote Phosphor Panels
Color temperature (CCT) for the Maverick is changed by replacing the Remote Phosphor panel
on the front of the fixture. The CCT is clearly labeled on each panel.
To change RP panels:
1. Loosen the two thumbscrews at the top of the fixture, and remove the top plate. The top
plate is tethered to the body of the fixture to avoid loss or damage.