Cineo Lighting Maverick - Manual (Page 9)

9
2. Remove the RP panel by sliding it up and out of
the fi xture. If the lamp is on, the output will be
cut when the panel is removed.
3. Insert a new panel into the slots and fi rmly
seat it into the bottom of the slot. If power is
applied, the lamp will turn on.
4. Replace the top plate, tightening the two
thumbscrews fi nger-tight.
Although no harmful UV emanates from the
fi xture, Maverick should only be used with the
remote phosphor panels in place. Although the
panels are extremely durable, avoid exposing
them to abrasive surfaces. Please reference
the Cineo Maverick catalogue for available color
temperature options.
Mounting and Accessory Attachment
Maverick has an integrated slot in front of the RP panel for
attachment of light control accessories, including the following:
900.0088 90º Louver
900.0089 4-leaf Barndoor set
902.0100 Snapbag™ softbox
902.0101 Chimera™ softbox
To install a light control accessory in the slot:
1. Rotate the accessory lock to the open position
2. Slide the accessory frame into the slot
3. Rotate the accessory lock to the closed position
Maverick also features two industry-standard 80/20 profi le slots
running vertically along the sides of the fi xture. Not only do these
provide an easy way to attach, detach and vertically position the
yoke to the lamphead, it provides a universal mounting solution
for other accessories, including handles, frames
and Cineo’s BackPak accessory bracket.
Additionally, all Cineo Maverick accessories
(battery plates, AC adapters, DMX adapters, etc.)
conform to a standard mounting hole pattern that
is repeated on the BackPak and several locations
on the yoke. This allows your Maverick unit to be
confi gured optimally for the application.