BOXLIGHT CP-320t - Manual (Page 27)

27
COMPUTER INPUT
NOTE : The Full screen cannot be selected after the Display area,
Display area H, and Display area V are adjusted.
Selects the area displayed by this projector. Select the resolution at
the Display area dialog box.
Display area
Adjustment of the horizontal area displayed by this projector. Press
the POINT LEFT/RIGHT button(s) to decrease/increase value and
then press the SELECT button.
Display area H
Adjustment of the vertical area displayed by this projector. Press the
POINT LEFT/RIGHT button(s) to decrease/increase value and then
press the SELECT button.
Display area V
When this function is on, SXGA image is fully displayed at 4 : 3
aspect ratio. It is displayed at 5 : 4 aspect ratio with this function off.
Full screen
Reset
Store
Closes the PC ADJUST MENU.
Quit
Other icons operate as follows.
3
To store adjustment parameters, move the red frame pointer to
the Store icon and then press the SELECT button. Move the red
arrow pointer to any of Mode 1 to 5 that you want to store to and
then press the SELECT button.
Reset all adjust parameters on the adjustment dialog box to
previous figure.
Mode free
Vacant Mode
Shows values of “Total dots,”
“Horizontal,” “Vertical,” “Display
area H,” and “Display area V.”
Close this dialog box.
To store adjustment data.
To clear adjustment data.
To clear adjustment parameters previously set, move the red
frame pointer to Mode free icon and then press the SELECT
button. Move the red arrow pointer to the Mode that you want to
clear and then press the SELECT button.
Display area
Press the POINT LEFT
/RIGHT button(s) to adjust
value and then press the
SELECT button.
Press the SELECT button at the
Display area icon and the Display
area dialog box appears.
This Mode has parameters being stored.
NOTE
● The Fine sync, Total dots, Display area (H/V), and Full screen
cannot be adjusted when “1035i (HDTV)” or “1080i (HDTV)” is
selected in the PC SYSTEM Menu (P23).