Constellation Audio Argo - Manual (Page 12)

12
13. Return/back
This button brings you back to the previous control screen. For example, from any input’s screen, such as XLR
1, it will take you back to the input selector screen.
14. Standby/power
Push this button to turn the Argo on and off. When you turn the unit on, it will take a few seconds for the power
supply and integrated amp to warm up. When the integrated amp is ready for use, its LCD screen will show the
most recently selected input. To put the unit in Standby mode, press this button again after turning on the
power.
Hold this button down for 5 seconds to turn the Argo off. The unit will enter cool-down mode for 10 seconds.
During cool-down, no buttons on the unit or remote will operate.
15. Multifunction button
The multifunction button serves different functions depending on which control screen is shown. A label on the
LCD display will show the function of the button. Note that when an input screen is shown, this button switches
between speaker and headphone output.
16. Mute
Press this to button to silence the Argo temporarily. The numerical volume readout will flash. Press again to
restore the audio. Because the Argo uses a relay to perform the mute function, it may take a second or so for
this control to respond.
17. Rear-panel power switch
This is the master power switch for the Argo. The
power/standby buttons on the front panel and remote
control will not function when this switch is flipped down.
To power up the Argo, first flip this switch up, then either
press the Standby button on the remote, or press the
front of the touchscreen and hit the onscreen Power
button or the middle button under the touchscreen.