Constellation Audio Argo - Manual (Page 8)

8
4. Headphone output
The Argo offers a single headphone output on a 1/4-inch/6.2mm jack. To activate this output (and mute the
speaker outputs), you must use the front-panel controls. The Argo’s headphone amplifier has enough power to
drive any dynamic or planar magnetic headphones. If your headphones have a 1/8-inch/3.5mm plug, use a
1/8-inch to 1/4-inch adapter. Many headphones come with the adapter.
5. XLR outputs
The two inner XLR connections on the rear of the Argo are outputs. These can be connected to a larger, more
power amplifier such as the Constellation Audio Hercules or Centaur. They can also be connected to a system
in a second room, or to a powered subwoofer.
Be sure to match the output to the correct channel on your amp. As you are looking at the back of the Argo, the
output on the left side is for the right channel, and the output on the right side is for the left channel.
To remove an XLR plug, push on the tab on the connector body and pull the plug out.