Constellation Audio Argo - Manual (Page 7)

7
2. RCA inputs
These unbalanced inputs are provided as a convenience for use with unbalanced signal sources. Whenever
possible, we recommend using XLR connections instead. Connecting to an unbalanced source is handled in
the same way an XLR balanced source.
The input numbers from left to right, looking at the back of the Argo are:
1
right
, 2
right
—2
left
, 1
left
.
IMPORTANT NOTE: To preserve true dual-mono operation, the Argo uses a symmetrical circuit layout. This
configuration requires that the Argo’s back panel connections be laid out a little differently from those on most
integrated amps. For example, the left-channel connection for RCA Input 1 is on the right side of the back
panel, and the right-channel connection is at the left side. Connecting the cables in the usual side-by-side
fashion will result in an incorrect installation and the mixing of sounds from different source devices.
3. Speaker outputs
The Argo offers one set of Argento speaker cable binding posts for each channel. Connect the marked
connector or cable conductor for the left speaker cable to the left positive (+ or red) binding post and the
unmarked connector to the negative (- or black) binding post underneath. Repeat with the right speaker cable.
Make sure the speaker cables on both channels are connected identically, with the marked cable conductor or
connector to red, unmarked conductor or connector to black. Do not allow the speaker cable terminals to touch
each other.