Constellation Audio Argo - Manual (Page 16)

16
Input setup screen
When you press the multifunction button labeled
Setup on the input screen, this screen will appear. It
allows you to set up a home theater bypass input,
and set minimum and maximum output levels.
To set minimum and/or maximum levels: Adjust the
Argo’s volume to the desired minimum or maximum
level, and press either the Set Min or Set Max
button, depending on which function you want, and
hit Apply to accept the setting. To clear the setting,
press either CLR Min or CLR Max as appropriate, or
press Default to clear both settings.
To set up a home theater bypass input: First select
the input you want to use for this function, then
adjust the volume on the Argo to the desired level.
Push the Set Min button, then the Set Max button,
then the Apply button. To clear these settings, press
CLR Min then CLR Max, or press Default.
Screen setup screen
To adjust LCD brightness: Press the + and – buttons
on the left side of the screen, on either side of the
dark dot.
To adjust LCD contrast: Press the + and – buttons on
the right side of the screen, on either side of the
half-dark/half-light dot.
To adjust LCD backlight timeout: Press the Timeout
button in the lower left corner to keep the screen lit
for 15 sec., 30 sec., 1 min., 5 min., 10 min., and
always on.
To accept or cancel screen setting changes: Press
the Apply or Cancel button, respectively.
To return to the factory default settings: Press the
Default button. This will bring up a screen asking
“Are you sure you want to set this device to its
default settings?” Hit the Yes button to go to default
settings, the No button to cancel.
Info screen
This screen is accessed using the multifunction
button labeled Info on the screen setup screen. It is
for servicing use only.