Decimator Design DMON-6S - Manual (Page 14)

DMON‐6S Hardware Manual for Firmware Version 1.1
Copyright © 2014 Decimator Design Pty Ltd, Sydney, Australia
14
3. SETUP / BACK2STATUS TIME (Parameter)
This is the time before the main menu is returned to Input Status after the last button press.
When the sub menu is highlighted, press ENTER to toggle through the following times:
1.) 5 seconds
2.) 15 seconds
3.) 30 seconds
4.) 1 minute
5.) 5 minutes
4. SETUP / AUTO SAVE (Parameter)
This parameter will determine if any changes will be saved to memory when changes are made.
When the sub menu is highlighted, press ENTER to toggle through the following selections:
3.) Yes
4.) No
5. SETUP / Demo Cycle (Parameter)
The Demo cycle setting is used for cycling through multiple layouts, windows or inputs on a time delay. When
the sub menu is highlighted, press the ENTER button to enter this sub‐menu.
Press the < and > buttons to move left or right through the following cycle types:
1.) None
2.) Output Select
3.) MV Windows
4.) MV Layouts
Note: The parameter will only be updated when leaving this sub‐menu.
6. SETUP / Demo Cycle Time (Parameter)
The Demo Cycle Time determines the amount of time to elapse before cycling to the next item. When the sub
menu is highlighted, press the ENTER button to enter this sub‐menu.
Press the < and > buttons to move left or right through the time until the unit moves to the next item in the
cycle.
Default time is 10 Seconds, Maximum time is 256 Seconds
Note: The parameter will only be updated when leaving this sub‐menu.
GPI PINS
PIN 1 = Ground PIN 14 = Window 5 Tally Red PIN 27 = Window 6 Tally Red
PIN 2 = RS485+ PIN 15 = Window 1 Select PIN 28 = Window 2 Tally Blue
PIN 3 = Window 1 Tally Green PIN 16 = Window 3 Select PIN 29 = Window 4 Tally Blue
PIN 4 = Window 3 Tally Green PIN 17 = Window 5 Select PIN 30 = Window 6 Tally Blue
PIN 5 = Window 5 Tally Green PIN 18 = Multi‐View Select PIN 31 = Window 2 Tally Yellow
PIN 6 = Window 1 Tally Red PIN 19 = Ground PIN 32 = Window 4 Tally Yellow
PIN 7 = Window 3 Tally Red PIN 20 = Ground PIN 33 = Window 6 Tally Yellow
PIN 8 = Window 5 Tally Red PIN 21 = RS485‐ PIN 34 = Window 2 Select
PIN 9 = Window 1 Tally Blue PIN 22 = Window 2 Tally Green PIN 35 = Window 4 Select
PIN 10 = Window 3 Tally Blue PIN 23 = Window 4 Tally Green PIN 36 = Window 6 Select
PIN 11 = Window 5 Tally Blue PIN 24 = Window 6 Tally Green PIN 37 = Output Select Toggle
PIN 12 = Window 1 Tally Yellow PIN 25 = Window 2 Tally Red
PIN 13 = Window 3 Tally Yellow PIN 26 = Window 4 Tally Red