Decimator Design DMON-6S - Manual (Page 3)

DMON‐6S Hardware Manual for Firmware Version 1.1
Copyright © 2014 Decimator Design Pty Ltd, Sydney, Australia
3
Main Menus
Upon power up the unit will start in the Main Menu pointing to Input Status.
The Main Menus are:
1. Input Status
2. Control
3. Routing
4. Colours
5. UMDs
6. Audio Meters
7. Graticules
8. GPI
9. Setup
Press the < and > buttons to move left or right through the menus.
To enter into a menu press the ENTER button.
Notes:
1. Defaults are highlighted in yellow.
2. When an option is changed, a highlighted
S will appear in the top right of the LCD screen and will
disappear when the options are saved after 10 seconds. Avoid powering down the unit during this
time.
3. You can always return to the Main Menu by pressing the BACK button twice.
4. As you move through the menus changing parameters, they will be instantly applied to the output
signal.
Input Status: (Has 2 states)
When pressing enter in the Input Status menu, will cycle between the status for input 1‐4 and 5‐6
(Default)
1:3G 1080p59.94
2:HD 720p50
3:SD 480i59.94
4:HD 1080i59.94
Current format on SDI Input 1
Current format on SDI Input 2
Current format on SDI Input 3
Current format on SDI Input 4
(After pressing ENTER once)
5:3G 1080p60
6:3G 1080p60
Current format on SDI Input 5
Current format on SDI Input 6
Control: (Has SUB‐MENUs)
Control
HDMI Output Type
HDMI RGB444 2C
Main Menu <==
Sub Menu
Parameter Window
When highlighted in the Main Menu, press the ENTER button to enter this sub‐menu.
Press the < and > buttons to move left or right respectively through the 12 menus below and press the BACK
button to go back to the Main Menu when finished.
The current value for each Sub Menu is shown in the Parameter Window.