Decimator Design DMON-6S - Manual (Page 6)

DMON‐6S Hardware Manual for Firmware Version 1.1
Copyright © 2014 Decimator Design Pty Ltd, Sydney, Australia
6
9. Control / Format Status (Parameter)
When an input is detected the DMON‐6S will display the format detected in the top left of each window by
default unless the location has been modified via the USB Control Panel. When the sub menu is highlighted,
press ENTER to toggle through the following selections:
1.) Show for 5 sec
2.) Show Always
3.) Off
10. Control / Audio Source ID (Parameter)
The Audio Source Identification icon will appear when selecting which window the audio will be passed from
to the output when in multi‐viewer mode. This option toggles whether the icon is shown to indicate the
window source the audio is coming from. This icon appears in front of the Format Status. When the sub menu
is highlighted, press ENTER to toggle through the following selections:
1.) Show for 5 sec
2.) Show Always
3.) Off
11. Control / Apply Tally to (Parameter)
The Apply tally to parameter allows the selection of the 3 different types of tally indicators. When a tally is
triggered it can be displayed as a small box on the bottom left (default position) of the inputs window or as
border around the window. The Tally can also fill the outside of the safe action box. When the sub menu is
highlighted, press ENTER to toggle through the following selections:
1.) Border
2.) Out Safe Action
3.) Tally Boxes
11. Control / Tally Transparency (Parameter)
The Tally transparency feature changes the transparency of the tally box / border / Outside safe Action. When
the sub menu is highlighted, press ENTER to toggle through the following selections:
1.) 0%
2.) 25%
3.) 50%
Routing: (Has SUB‐MENUs)
Routing
Window 1 Source
Input 1
Main Menu <==
Sub Menu
Parameter Window
When highlighted in the Main Menu, press the ENTER button to enter this sub‐menu.
Press the < and > buttons to move left or right respectively through the 6 menus below and press the BACK
button to go back to the Main Menu when finished.
The current value for each Sub Menu is shown in the Parameter Window.