BellSouth E911 - Manual (Page 100)

Wireless E911 Guide CG-EWCG-001
BellSouth Wireless E9–1–1/SS7 Interconnection
Guide Issue 3, January 6, 2004
- continued -
Orreq
Parameters
ISUP Parameters Value
Digits(Dialed) Called party number (see Note 1
below) pANI (see Note 1 below)
MDN (aka: CBN) Calling party number (see Note 3
below) CBN or the non-dialable number
used in lieu of a real callback
DMH_BillingDigits Charge Number (see Note 3 below) CBN or the non-dialable number
used in lieu of a real callback (see
Note 3 below)
GenericDigits Generic digits parameter (see Note 2
below) NOT ALLOWED (see Note 2
below)
GeographicPosition Calling geodetic location n/a
n/a Originating Line Information (OLI) If included, use value 61 OR 62
NOTES:
1. The pANI is used as the Called party number. In BellSouth the MSC MUST use dedicated
trunks to the Emergency Services Network Entity (ESNE) to route the Emergency Services
Call (ESC).
2. The Generic Digits Parameter IS NOT ALLOWED TO BE SENT IN THE IAM WHEN
USING WRLS_CLD!
3. The Calling Party Number MUST be included in the IAM message. The Charge Number may
also be included in the IAM, but if so it MUST be the SAME as the Calling Party Number.
Although Charge Number Parameter is allowed as an optional parameter, it is ignored by the
NDET when using either of the WRLS_xxx signaling options.
A.8.4 ISUP Initial Address Message Parameter Contents for CAS
There are no ISDN PSAPs in the BellSouth E9-1-1 serving area. Therefore the interconnection
arrangement shown in Table "D" below IS NOT SUPPORTED.
Shown here for reference ONLY.
WARNING
This IS NOT SUPPORTED in BellSouth.
Extracted in part from Annex D: of J-STD-036-A
Table "D" ISUP Initial Address Message Parameter Contents for CAS.
Page 90