Metrohm 850 Professional IC Anion MCS Prep 3 - Manual (Page 44)

2.10 High pressure pump
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
34 ￭￭￭￭￭￭￭￭
850 Professional IC –Anion – MCS – Prep 3
2.10.2 Deaerating the high pressure pump
The high pressure pump will only operate perfectly if the pump head con-
tains no more air bubbles. Therefore it must be deaerated during initial
start-up and after every change of eluent.
Caution
The high pressure pump must not be deaerated before the initial start-
up (see Chapter 3.1, page 70).
Deaerate the high pressure pump as follows (see Figure 19, page 35):