Metrohm 814 USB Sample Processor - Manual (Page 36)

3.8 Connecting MSB devices ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
28 ￭￭￭￭￭￭￭￭ 814 USB Sample Processor
3.8.2 Connecting a stirrer or titration stand
You can use a magnetic stirrer 801 Stirrer or 803 Ti Stand (stirring "from
below") or the 804 Ti Stand with a rod stirrer 802 Stirrer (stirring "from
above").
Connect a stirrer or a titration stand as follows:
1 Connect a stirrer or titration stand
￭ Exit the control software.
￭ Connect the connection cable of the magnetic stirrer or of the
titration stand to one of the sockets marked with MSB on the
rear of the control instrument.
￭ If desired, connect the rod stirrer to the stirrer socket (with stirrer
symbol) of the titration stand.
￭ Start the control software.
USB 1 Contr. MSB 2 MSB 3
Figure 20 Connecting MSB stirrer
Figure 21 Rod stirrer and titration stand