5 connecting an iconnect, Connecting an iconnect, Figure 16 – Metrohm 907 Titrando User Manual
Page 38
3.6 Connecting sensors
■■■■■■■■■■■■■■■■■■■■■■
30
■■■■■■■■
907 Titrando
3.6.4
Connecting a temperature sensor or an electrode with integrated
temperature sensor
A temperature sensor of the Pt1000 or NTC type can be connected to the
Temp. connector.
Connect the temperature sensor or the electrode with integrated temper-
ature sensor as follows:
1 Insert the plugs of the temperature sensor into the Temp. sockets of
the Titrando.
Figure 16
Connecting a temperature sensor or an electrode with
integrated temperature sensor
NOTE
Always insert the red plug into the red socket. This is the only way
that shielding against electrical interference can be ensured.
3.6.5
Connecting an iConnect
An external 854 iConnect measuring interface can be connected to the
907 Titrando.
Connect the iConnect as follows:
1 Plug the iConnect plug into the iConnect socket of the 907
Titrando.
Take care to ensure that the marking on the plug matches the mark-
ing on the Titrando as shown in the figure.