Metrohm 805 Dosimat - Manual (Page 15)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
805 Dosimat ￭￭￭￭￭￭￭￭ 7
3 Installation
3.1 Setting up the instrument
3.1.1 Packaging
The instrument is supplied in highly protective special packaging together
with the separately packed accessories. Keep this packaging, as only this
ensures safe transportation of the instrument.
3.1.2 Checks
Immediately after receipt, check whether the shipment has arrived complete
and without damage by comparing it with the delivery note.
3.1.3 Location
The instrument has been developed for operation indoors and may not be
used in explosive environments.
Place the instrument in a location of the laboratory suitable for operation
and free of vibrations, if possible protected from corrosive atmospheres and
contamination by chemicals.
The instrument should be protected against excessive temperature fluctua-
tions and direct sunlight.
3.2 Connecting the 805 Dosimat
Note
In the case of a Titrando with exchange unit, the MSB Port 1 is used by
the internal drive. The MSB 1 is therefore not available for an 805 Dosi-
mat .
The 805 Dosimat is controlled by devices which are equipped with a 'Me-
trohm Serial Bus' (MSB). These are e.g. Titrandos or sample changers.
Connect the 805 Dosimat on the rear of the corresponding device to one
of the connectors (MSB 1/MSB 2 to MSB 4 ). The 805 Dosimat can how-
ever not be connected to devices with an MSB connector which do not
support tandem dosing.