Metrohm 850 Professional IC Anion MSM-HC MCS LP-Gradient - Manual (Page 23)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
850 Professional IC–Anion – MSM-HC – MCS – LP Gradient
￭￭￭￭￭￭￭￭ 13
3 Installation
3.1 About this chapter
The Installation chapter contains
￭ this overview
￭ a brief set of instructions for the initial installation of the 850 Profes-
sional IC – Anion – MSM-HC – MCS – LP Gradient (see Chapter 3.2,
page 13) as an isocratic system. At each step you will find cross-ref-
erences to more detailed installation instructions for individual compo-
nents, should you require such aids.
￭ a brief set of instructions for the initial installation of the low pressure
gradient (see Chapter 3.3, page 16). At each step you will find cross-
references to more detailed installation instructions for individual com-
ponents, should you require such aids.
￭ an installation diagram (see Figure 3, page 18), showing a com-
pletely installed instrument.
￭ several chapters with detailed installation instructions for all compo-
nents, including those that are already installed at the time the instru-
ment is delivered.
3.2 Initial installation
NOTE
A large number of the capillary connections are already connected at
the time the instrument is delivered.
The 850 Professional IC – Anion – MSM-HC – MCS – LP Gradient is sup-
plied the same way as an isocratic instrument, i.e. it can be put into oper-
ation with minimum effort for usage with only one eluent. Carry out the
following steps:
Installing 850 Professional IC – Anion – MSM-HC – MCS –
LP Gradient
1 Setting up the instrument
See Chapter 3.5, Page 20.