Metrohm 850 Professional IC Anion MSM-HC MCS LP-Gradient - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
850 Professional IC–Anion – MSM-HC – MCS – LP Gradient
￭￭￭￭￭￭￭￭ III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.2 Intended use ......................................................................... 3
1.3 About the documentation ................................................... 4
1.3.1 Symbols and conventions ........................................................ 4
1.4 Safety instructions ................................................................ 5
1.4.1 General notes on safety ........................................................... 5
1.4.2 Electrical safety ........................................................................ 5
1.4.3 Tubing and capillary connections ............................................. 6
1.4.4 Flammable solvents and chemicals ........................................... 6
1.4.5 Recycling and disposal ............................................................. 6
2 Overview of the instrument 8
2.1 Front ...................................................................................... 8
2.2 Rear ...................................................................................... 10
3 Installation 13
3.1 About this chapter .............................................................. 13
3.2 Initial installation ................................................................ 13
3.3 Installation of the low pressure gradient ......................... 16
3.4 Installation diagram .......................................................... 17
3.5 Setting up the instrument .................................................. 20
3.5.1 Packaging .............................................................................. 20
3.5.2 Checks .................................................................................. 20
3.5.3 Location ................................................................................ 20
3.6 Capillary connections in the IC system ............................. 20
3.7 Rear of the instrument ....................................................... 22
3.7.1 Rollers and handle ................................................................. 22
3.7.2 Positioning and connecting the detector ................................ 25
3.7.3 Transport locking screws ....................................................... 27
3.7.4 Leak sensor ........................................................................... 27
3.7.5 Drainage tubing ..................................................................... 28
3.8 Capillary and cable feed-throughs .................................... 30
3.9 Eluent ................................................................................... 33
3.9.1 Connecting eluent bottle ....................................................... 33
3.10 Eluent degasser ................................................................. 37
3.11 Low pressure gradient ....................................................... 38