Metrohm 870 KF Titrino plus Installation - Manual (Page 21)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Tutorial
870 KF Titrino plus ￭￭￭￭￭￭￭￭ 15
3 Tutorial
3.1 Configuration
Note
External devices (printer, balance and USB stick) must be connected to
the USB connector and, if necessary, be switched on before switching
on the 870 KF Titrino plus.
3.1.1 Switching the instrument on and off
Switching on the instrument
Proceed as follows:
1 ￭ Press the red [STOP] key.
As soon as the buret unit has been recognized the following mes-
sage appears:
￭ Confirm the message with [OK].
The request to carry out the PREP function appears:
All tubings and the cylinder are rinsed with the PREP (Preparing)
function. The preparing of the buret unit is described in chapter
3.2.2, page 26. The buret unit must however first be configured
(see Chapter 3.1.3, page 16).
￭ Confirm the message with [OK].
The main dialog is displayed: