Metrohm 870 KF Titrino plus Installation - Manual (Page 22)

3.1 Configuration ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
16 ￭￭￭￭￭￭￭￭ 870 KF Titrino plus
Switching off the instrument
Proceed as follows:
1 ￭ Keep the red [STOP] key pressed down.
A progress bar is displayed. If the key is released during this time,
then the instrument will not be switched off.
￭ Keep the [STOP] key pressed down until the progress bar is fin-
ished.
3.1.2 Setting the dialog language
If the dialog does not appear in the appropriate language, the dialog lan-
guage can easily be changed. Proceed as follows:
1 Open the system settings
￭ In the main dialog, select Menu and press [OK].
￭ In the main menu, select System and press [OK].
￭ In the system menu, select Settings and press [OK].
2 Change the language
￭ Select Language and press [OK].
￭ Select the required language and press [OK].
￭ Press [BACK].
If no second dialog language is available, a corresponding language
file must first be loaded into the instrument. The chapter Instru-
ment diagnosis in the manual of the 870 KF Titrino plus describes
how to proceed.
3.1.3 Adding and configuring a solution
Note
The buret unit must be attached before carrying out the instructions lis-
ted below.