E-flite DHC-2 Beaver 25e ARF User Manual
Page 32
32
E-flite DHC-2 Beaver ARF Assembly Manual
14. Slide the fin up slightly so the rudder control horn
can be installed on the rudder control rod. Use a setscrew
and the provided hex wrench to tighten the setscrew on
the flat area of the control rod. Note that the tab on the
horn faces toward the top of the fuselage when installed.
Note: It is very important to use threadlock to ensure this
assembly does not come apart during flight.
Note: Do not mix up the rudder and tail wheel
control horns. They are packaged separately as they
are not interchangeable.
15. Wick thin CA into the joint between the fuselage
and fin. Make sure the fin is glued into the slot in the
fuselage, as well as to the top of the fuselage.
Note: If you are installing floats please continue to the
next section of the manual.
16. Install the tail wheel and control horn at this
time. Use threadlock on all set screws to ensure
trouble-free operation.