E-flite DHC-2 Beaver 25e ARF - Manual (Page 42)

42 E-flite DHC-2 Beaver ARF Assembly Manual
 7. Drill a 1/8-inch (3mm) hole in the bottom of the
fuselage near the landing gear. Route the float pushrod
through the hole and into the fuselage. Use silicone
adhesive to glue the pushrod tube to the fuselage. Use
thin CA to glue the landing gear plugs to the fuselage at
this time as well. You may also opt to use clear tape to
install the landing gear plugs in the fuselage if you might
change from floats to wheels from time to time.
 8. Connect the pushrod cable to the connector. The
pushrod must be secured inside the fuselage. Wrap string
around the pushrod tube and the cross member of the
radio tray. Soak the string with thin CA to secure the
pushrod location inside the fuselage.