E-flite DHC-2 Beaver 25e ARF - Manual (Page 45)

45 E-flite DHC-2 Beaver ARF Assembly Manual
 7. Use canopy glue to attach the front windscreen to the
fuselage. Scuff the covering and windscreen where they
contact each other using fine sandpaper to provide a
surface for the adhesive to bond to.
 8. Use medium CA to glue the rear cockpit floor blocks
to the sides of the fuselage slightly below the level of the
center side window. There will be two blocks on each
side of the fuselage as shown.
 9. Remove the backing from the adhesive strips on the
bottom of the seat backs. Attach the seat backs to the
rear cockpit floor.