Bradley Smoker MG-2/TT - Manual (Page 11)

Installation Instructions continued . . .
Step 6: Connecting optional hot water heater
NOTE: 240/208 or 277 voltage is required for hot water
heater. Refer to the installation manual provided with the
hot water heater for further installation information.
1. Remove the two screws from the back of the water
heater. Attach the bracket with the screws as shown in
Figure 6a.
2. Hang the water heater on the rear frame member to the
right of the vertical frame member (see Figure 6b).
3. Connect the 1/2" flexible hose from the cold water
supply stub-out to the hot water heater inlet.
4. Connect the 1/2" flexible hose from the hot water
heater outlet to the supply inlet on the solenoid valve
assembly.
11
Express® Lavatory System - MG-Series with TouchTime® Control
Installation Instructions MG-2/TT
Bradley Corporation • 215-1480 Rev. E; EN 06-915 2/8/07
RECOMMENDED 240V/208V
ELECTICAL BOX LOCATION, 4" x 4"
OPTIONAL 240V/208V ELECTICAL
BOX LOCATION, 2-1/2" x 4"
COLD WATER
SUPPLY
2" (51mm)
REF. ONLY
WATER HEATER EX95TMLB
MOUNTING CLIP
INLET
OUTLET
VERTICAL FRAME
MEMBER
COLD WATER
SUPPLY
HANG WATER HEATER
ON REAR FRAME MEMBER
TO THE RIGHT OF THE
VERTICAL FRAME MEMBER
REFERENCE WATER HEATER
INSTRUCTIONS FOR REQUIRED
ELECTRICAL CONNECTIONS.
FOR CLARITY,
BOWL NOT SHOWN.
WATER HEATER EX95TMLB
(269-1767), 240V/208V
5-1/4" x 9-3/4" x 2-1/16"
WATER
HEATER
BRACKET
(140-945)
SCREWS
REMOVE (2) SCREWS FROM
BACK OF WATER HEATER.
ATTACH BRACKET WITH
SCREWS AS SHOWN.
Figure 6c
Figure 6b
Figure 6a