Getting started – HCO NX50 User Manual
Page 4
4
GETTING STARTED
SD MEMORY CARD
The camera supports both SD and SDHC memory cards from 32 MB to 16 GB. The camera does not
have any internal memory.
1. Open bottom door
2. Insert SD card with marked side facing front of camera
3. Push gently until card clicks into place
4. Push card again to remove
Note 1: Ensure SD card slider is NOT in locked position.
Note 2: It is always recommended to test the SD card by taking some pictures to ensure SD
card works properly before leaving camera for extended periods of time.
BATTERIES
This camera is designed for Alkaline, Lithium, or Nickel Metal-Hydride (NiMH) batteries. A 6V AC to
DC power cord (sold separately) can be attached to the bottom port of the camera.
1. Insert 8 AA batteries while ensuring polarity (+ -) is correctly orientated
Note: 6V DC power can be used with or without batteries connected. Power by-passes
batteries when 6V power is connected. Solar panels DO NOT charge batteries directly located
in the camera.
CHECKING BATTERY LEVEL
1. Battery level can be seen in bottom left corner of viewer screen
TESTING AND WORKING MODES
The camera has two modes: Set Mode and Work Mode.
This camera has a 3-way switch. The center position is SET Mode, right position is WORK
Mode, and left position is OFF.