JK Audio BlueKeeper - Manual (Page 13)

13
Connection - Alternate Setup Diagrams Simple Setup for Mixer
Number of mics
depends on mixer
Caller to any line
level input on mixer Aux Send A (pre-fader) on mixer
to Send 1 on BlueKeeper,
Mic/Line button out (Line)
Use Main Outputs,
USB or Firewire
connectors to
send audio to
recording device
For whichever input channel you have the Caller connected to, turn the
corresponding Aux A control to minimum (usually hard left). All other Aux
A controls should be set for what you want to send to the phone line.
Each Aux Send bus is completely separate from all other outputs, so
these Aux controls will not affect what is heard on the Main outputs or on
any other Aux buses. This Aux Send bus should be pre-fader if possible
so you can use the Level controls (faders) to set each channel at the
main recording output without changing the levels you send to the caller.
Figure 5: Simple Setup for Mixer