JK Audio BlueKeeper - Manual (Page 7)

7
Features—Rear View
Figure 2: Rear View
12. Bluetooth antenna - do not obstruct.
13. Caller Output - Male balanced XLR output contains only the
caller’s voice at line level.
14. Send 1 Input - Female balanced XLR input for signals going
out to the cell phone. Mic or line level input.
15. Mic / Line switch - Sets the front end sensitivity of the Send 1
XLR jack. Set to Mic if you intend to connect a dynamic micro-
phone directly to the Send 1 jack. Set to Line if you are con-
necting to the output of a mic pre-amp or mixer.
16. Send 2 Stereo Input - 3.5mm mono mini jack input for signals
going into the cell phone. Line level.
17. Stereo Output - 3.5 mm stereo mini jack line level output con-
tains both Send and Caller audio channels with levels deter-
mined by the Send 1 and Send 2 level controls and the Caller
level control. Left channel contains your local Send audio and
right channel contains the Caller's audio from the cell phone.
18. Mono Output - 3.5 mm mono mini jack output contains a mix of
Send 1, Send 2 and Caller audio with levels controlled by
each of the input control knobs on the front of the unit. This
output is at Mic level and is suitable for connecting to the Mic
input on a computer or other recording device.
19. Power Jack - For connection only to the supplied 9VDC regu-
lated power supply.
12 13 14 15 16 17 18 19