Kino Flo Imara S10/S6 DMX - Manual (Page 15)

15
Troubleshooting
Lamps Fail to Light:
• With the power switch in the ON position, the red light should be on. If it is not,
voltage is not present. Check the power feed. Check the fuse on the fixture and
replace if “blown” or “open” with same type of fuse rating.
• Each ballast operates 2 lamps. If one or both lamps do not light, replace with
new lamps that have been tested to work. If tested lamps still do not light,
replace ballast.
• After having checked that lamps and ballasts are working properly, turn off power
to the fixture for 60 seconds and restart.
• With DMX cable connected, if yellow light is off, there is no DMX signal. Establish
a valid DMX signal.
• With DMX cable plugged in and yellow indicator on:
1. Address must be between 001 and 512.
( Note: 0 or 513 and higher are invalid addresses.)
2. The dimmer setting on the lighting board must be up in the full mode.