Kino Flo ParaZip 400/200 DMX - Manual (Page 11)

11
Trouble Shooting
LAMPS FAIL TO LIGHT:
• With the power switch in the ON position, the red light should be on. If it is not,
voltage is not present. Check your power feed. Check the fuse on the fixture and
replace if necessary (5 x 20mm, T3.15AH/250V, Time Delay Type).
• The onboard manual dimmer should be full up, turned completely clockwise.
• Check lamp contact. Lamps must be properly seated. If one lamp is not making contact
or is burned out, two lamps will be off.
• Replace lamp or lamps.
• After having checked that lamps are correctly seated, turn off power to the fixture for
60 seconds and restart.
• With DMX cable connected, if yellow light is off, there is no DMX signal. Establish a valid
DMX signal.
• With DMX cable plugged in and yellow indicator on:
1. Address must be between 001 and 512. 0 and 512 and higher are invalid addresses.
2. The dimmer setting on lighting board must be in the full up mode.
3. The last fixture must have the DMX termination switch set to END OF LINE.
Numerous terminated fixtures on a DMX run will result in DMX signal corruption.