Krell 707 Evolution - Manual (Page 3)

their original function as vol-
ume level controls after 3 sec-
onds of inactivity.
MENU FUNCTIONS
32 Menu Button/Key
Accesses the setup menu and
on-screen menu display.
33 Previous Button/Key
Return to the previously dis-
played setup menu screen.
34 Enter Button/Key
Accepts setup menu selec-
tions, accept an input device
selection, or displays current
system conditions.
35 Directional Buttons/Keys
Up and Down Keys. Adjust
volume, and adjust balance if
the balance function is acti-
vated. In the operational mode,
the up and down directional
keys select EQ memory.
Right Key. In the operational
mode, the right arrow key
engages Digital Room EQ.
All Keys. In the setup menu, all
four directional keys navigate
the on-screen menus.
PROCESSOR FUNCTIONS
36 Save Button/Key
Saves system configuration
settings. Press and hold this
button or key to activate. This
function is also used to pro-
gram a learning remote.
37 Recall Button
Recalls previously stored sys-
tem configuration settings. To
return configuration settings to
factory default, hold the recall
button and press the power
button with the Evolution 707
in the operational mode.
38 Mute Button/Key
Mutes the Evolution 707 out-
put. When this function is
active, VOLUME MUTE appears
in the front panel display.
39 Volume Knob/Keys
Scrolls through menu selec-
tions, adjusts output for entire
system, adjusts volume and
balance levels for the center
and surround/back loudspeak-
ers, and subwoofer. Vol-ume
and balance levels appear in
the front panel display.
Krell Evolution 707 3
Figure 2 The Evolution 707 Remote
All functions on the
remote control dupli-
cate front panel func-
tions.
19 Mode 1 Button/Key
20 Mode 2 Button/Key
Selects available processing
modes (Dolby Digital, DTS, PLII
Movie, etc.) for incoming sig-
nals from an audio source. The
signal default mode is always
stored in Mode 1. Use the
Mode 1 button or key to
select the default mode. All
modes that are available for
the same signal are automati-
cally stored in Mode 2. Scroll
through these modes using
the Mode 2 button or key. The
last mode displayed in the
Mode 2 list is the selected
mode. The Evolution 707 auto-
matically selects the assigned
mode for the available signal
from the source.
21 Pro Logic II Button/Key
Selects Dolby Pro Logic II
modes for Dolby Surround
encoded material, including
laser discs, videotapes, televi-
sion broadcasts, and com-
pact discs. The red LED
illuminates when Dolby Pro
Logic II decoding is selected.
Note: These modes are
selected automatically if Dolby
Digital source material is en-
coded for Pro Logic. To turn
off these modes, press the
Pro Logic II button.
DISPLAY WINDOW
22 Front Panel Display
Provides status messages for
Evolution 707 operations,
including volume and balance
level, decoding mode, and
zone information. When a
new device is selected, the
physical inputs are displayed.
The display turns off after 60
seconds of inactivity.
SOFTKEY BUTTONS/KEYS
23-26 Softkeys (For future use.)
INDIVIDUALIZED
CHANNEL TRIM
The center, surr, back, and sub
buttons and the center, sub, and
rear keys make temporary loud-
speaker output adjustments of
+/- 10 dB. These temporary
adjustments revert to 0 dB
when a new device is selected
or when the system is pow-
ered down.
27 Center Button/Key
Adjusts the center loudspeak-
er volume. Press the center
button or key, then use the
volume knob or up and down
directional keys to make
adjustments.
Phantom Center. Press the
center button or key twice
activate. Press the center but-
ton twice again to deactivate.
28 Surr Button
Adjusts the volume of the sur-
round loudspeakers from the
front panel. Press the surr but-
ton; use the volume knob or up
and down direction keys to
adjust the surround loudspeak-
ers. SURROUND TRIM appears
on the front panel display.
29 Back Button/Rear Key
Adjusts the volume of the
back loudspeakers. Press the
back button once or the rear
key twice, then use the vol-
ume knob or the up and down
directional keys to adjust the
volume of the back loud-
speakers. BACK appears on
the front panel display.
Press the rear key once to
access and adjust the sur-
round loudspeakers.
30 Sub Button/Key
Adjusts the subwoofer vol-
ume. Press the sub button or
key; use the volume knob or
the up and down directional
keys to adjust the volume.
31 Balance Button/Key
Adjust the main left/right loud-
speaker balance. Press the
balance button or key, then
use the volume knob or the up
and down directional keys to
adjust the balance. Balance
levels may be adjusted in .5 dB
increments, up to 6 dB, and
appear on the front panel dis-
play. The center position is dis-
played as BAL 0.
Balance level keys revert to