Krell Phantom II Manual - Manual (Page 27)

27
Connection Steps
Position the preamplifier where you intend to use it in your system.
The following steps describe how to connect an Phantom II preamplifier to your
system:
1. Neatly arrange and organize wiring to and from the Phantom II preamplifier and
all components. Separate AC wires from audio cables to prevent hum or other
unwanted noise from being introduced into the system.
2. Connect the outputs of your source equipment to the appropriate CAST (18),
balanced (15), single-ended (16), or tape inputs (17) on the Phantom II.
3. Connect the appropriate main outputs (20) on the Phantom II to your amplifier.
4. Connect the supplied AC power cord to the IEC power cord receptacle (27).
5. Plug the AC power cord into AC power. The front panel display (3) scrolls
through Phantom II SOFTWARE VERSION, and the red stand-by LEDs illuminate (7),
indicating that the Phantom II preamplifier is in stand-by mode. The scrolling
stops when the Phantom II is ready to be powered on.
Note
Use only the power cord provided or Krell Vector HC power cable with the preamplifier
to make the connection to AC power. Operation with a power cord other than the one
supplied by Krell could induce noise, limit current, or otherwise impair the ability of the
preamplifier to perform optimally.
(SECTION FIVE: Connecting the Phantom II to Your System continued)