LandAirSea GPS Tracking Key Pro User Guide - Manual (Page 20)

LandAirSea Tracking Key/Pro ® User Guide
LandAirSea, Inc | User Guide 2010 20
1
If you choose to install Google Earth® in another
folder location on your computer, other than the default
location. You can manually set the connection path to Past
Track.
2 Set the port selection for your GPS device. This is
done automatically in the Past Track program, but you can
set the port for troubleshooting purposes.
3 Set data filters for your individual needs. You can
change the various filters for your device if necessary, but it
is best to leave the default settings.
4 File Open/Save dialog. This setting is also used for
troubleshooting and is best left unchecked.
5 You can set the sampling rate at which your GPS
device records data. Default is 1 second. Maximum sampling
rate is 5 seconds.
6 In Power Saving Mode, our GPS device goes to sleep
after 2 minutes to extend battery life. You can disable Power
Saving mode if you would like your device to record
continuously. NOTE: Disabling the power saving mode will
drastically reduce the battery life as the device will no longer
go to sleep.
7. Restores all Firmware Settings to original factory settings.