Network settings (for network models), Installing the printer onto the network, Network settings (for network models) -2 – Pantum P3205D User Manual
Page 35: Installing the printer onto the network -2
4-2
4. NETWORK SETTINGS (FOR NETWORK MODELS)
You may need to set some network parameters for the printer. These parameters can be set
from the embedded Web server.
4.1. INSTALLING THE PRINTER ONTO THE NETWORK
In this setting, the printer is directly connected to the network and can be set to allow all
computers on the network to print directly from the printer.
1. Before turning on the printer, connect the network cable to the printer’s network port so that
it is directly connected to the network.
2. Turn on the printer and wait for the status indicator on the control panel to display the
Ready status, as shown below.
3. Insert the printer’s CD-ROM into your computer. If the installer software does not launch
automatically , please browse to the “setup.exe” file on the CD-ROM, and then double-click to
run the file.
4. Follow the operation instructions of the installer.
5. Continue to complete the installation.
Note:
• When the installer prompts you to select a printer, you can select the
appropriate printer name from the Detected Printer list;
• If the printer name does not appear in the Detected Printer list, please click
Refresh and search again for printers on the network;
• If you know the IP address of the printer to be connected, you can select “Specify
an IP Address for Installation” to enter the IP address to enable connection.