Software failure, Common troubleshooting, Common problems – Pantum P3205D User Manual

Page 61: Software failure -7 8.3. common troubleshooting -7, Common problems -7

Advertising
background image

8-7

8.2. SOFTWARE FAILURE

Problem

Solution

Pantum 3000 Series Printer Driver cannot be

found in the printer and fax folders.

Reinstall the printer driver.

Ensure that the USB interface cable and the

power cord are properly connected.

The printer is in Ready mode but it will not

perform any print job.

If the failure still exists after restarting the

printer, please reinstall the printer driver.

Ensure that the USB interface cable is properly

connected.

Failed to install the driver

Check whether the print spooler service is

enabled.

Check the power supply and the connection of

the printer.

The driver cannot be used if the IP address

of the printer has been changed

Modify the port IP address of the printer driver.

If the above method does not work, please

reinstall the printer driver.

It is recommended that a fixed IP address

should be set to the network printer.

In the DHCP network, it is recommended to

bind the IP address with the MAC address of

the printer.

8.3. COMMON TROUBLESHOOTING

8.3.1. COMMON PROBLEMS

Problem

Cause

Solution

Problems with the Printer

The printer does

not work

The cable between the computer

and the printer is not connected

properly.

Error in specifying the print port.

The printer is offline and Use

Printer Offline is checked.

The printer has not recovered

from an internal error, such as a

paper jam, paper empty, etc.

Disconnect and then reconnect the

printer cable.

Check the Windows printer settings

to ensure that the print job has

been sent to the correct port. If

the computer has more than one

port, make sure that the printer is

connected to the correct port.

Make sure that the printer is in the

normal online status.

Problems with Paper Handling

Paper feed failure

The print media has been loaded

incorrectly.

The print media is out of the

supported media range.

The feed roller is dirty.

Please correctly load the print media.

If you are using special print media for

printing, please print with the manual

feeder tray.

Please use the print media within the

specification range.

Clean the feed roller.

Advertising
This manual is related to the following products: