Reloop IQ.2+ USB - Manual (Page 31)

• REVERB = reverb effect
Simulates reflecting sound waves in a naturally restricted area.
Time parameter value: 0 – 100%
Direct bar assignment: 0/20/40/60/80/100%
By turning the X parameter knob -25 the value will be changed in steps of 1. Push,
hold and turn the X parameter knob -25- and the value will change in steps of 10.
Y parameter dry/wet value: 0 – 100%
• TRANS = transformer effect
Creates the signal's chopping by fading in and out, similar to fast cutting with the
crossfader.
Time parameter value: 25 – 65000 msec.
Direct bar assignment: 500/1000/2000/4000/8000/16000 msec.
By turning the X parameter knob -25- the value changes in steps of 1. Push, hold
and turn the X parameter knob -25- and the value will change in steps of 100.
Y parameter dry/wet value: 0 - 100%
• Pitchshifter = pitchshifter effect
Raises or lowers the signal's tone pitch.
Time parameter value: -100 – 100%
Direct bar assignment: -100/-50/-33/0/50/100%
By turning the X parameter knob -25- the value changes in steps of 1. Push, hold
and turn the X parameter knob -25- and the value will change in steps of 10.
Y parameter dry/wet value: 0 - 100%
15. Crossfader effects [see designations; numbers 9, 13, 14, 15, 21, 22 a – c, 24, 25]
Besides the DSP effect unit the Reloop IQ2+ mixing console also offers three
novel crossfader effects. In order to operate these effects there are two
modes at one's disposal:
Fader mode:
First of all switch the crossfader effect switch -15- to the “fader” position. The
active crossfader effect -22 a, b or c- will be illuminated. The active channel is
displayed by the crossfader-effect assignment LEDs -20-; additionally the active
channel is shown on the LCD info display -13;I-. Now move the crossfader -21- to
the opposite side in order to manually modulate the crossfader effect. You will
notice that the crossfader effect will change depending on the crossfader's
position.
Auto mode:
Switch the fader effect switch -15- to the “auto” position. By pushing the desired
crossfader effect button -22 a, b or c- an automatic cross-fading to the opposite
channel will be carried out.
NOTE!
Only the master effects -14- can be monitored by using the CueFX LED
button -9-, the crossfader effects -22- can not be monitored.
31
ENGLISH
IM_IQ2.qxp 10.07.2008 14:28 Uhr Seite 31