Revel C30 - Manual (Page 10)

Figure 9. Installing a
set of spikes on a
REVEL PERFORMA C30
loudspeaker.
INSTALLING SPIKES
If desired, you can add spikes to the REVEL PERFORMA C30
loudspeaker as follows:
1. Remove the spike feet, lock nuts, and wrench from the plastic bag.
2. Lay the REVEL PERFORMA C30 loudspeaker on its top on a
carpeted area or soft towel. Use caution to avoid touching the
transducers and grille. Remove the black screws that serve as
glides on the three feet and store them for future use. Start a set
of spikes, as shown in Figure 9. Be sure to thread each spike the
same amount to achieve a level placement.
NOTE: If you want to place the loudspeaker on a hardwood or tile
floor, or on a large-screen television set, use the round ends with
optional supplied covers. Further adjustment of each spike may be
necessary due to uneven floors.
3. (Optional) To tilt the REVEL PERFORMA C30 loudspeaker
down (or up) so that it is on-axis with the listener(s), perform
the following:
• For a downward tilt, adjust the two front spikes for decreased
extension and the rear center spike for increased extension to
achieve the amount of tilt you desire.
• For a upward tilt, adjust the two front spikes for increased
extension and the rear center spike for decreased extension to
achieve the amount of tilt you desire.
4. Using the supplied wrench, tighten a lock nut onto each spike.
REVEL PERFORMA C30
Owner’s Manual
10
7⁄ 8" max.
Lock Nut
HARD FLOOR OR TV
round end
or Dome
Cover Slip
Cover
Foot
Spike
Lock Nut
CARPETED FLOOR
spike end
Foot
1 1⁄ 8" max.
Spike
Carpeted Area or Soft Towel
REVEL PERFORMA C30
(on its top)