Syba SB-ATA8212-133R - Manual (Page 21)

RAIDExpress 133 RAID USER MANUAL
37
Driver Installation
This section details the procedures to install the RAIDExpress 133 ATA RAID
Controller driver under the following various operating systems. Before starting to
install this driver, please make sure that RAIDExpress 133 ATA RAID Controller has
already been properly setup in the system.
l Windows XP
l Windows 2000
l Windows 98/ME
l Windows NT 4.0
RAIDExpress 133 RAID USER MANUAL
38
Windows XP
Install the driver during Windows XP installation
1. Start Windows XP installation.
Warning: Because of the different selections of the
following installation methods, the time when step2 starts
will be different.
l Boot from floppy with Windows installation diskette.
l Boot from floppy with un-installable diskette.
l Boot from CD-ROM with Windows installation CD.
2. When the message “Press F6 if you need to install third party SCSI or
RAID driver ” appears on the bottom of the screen, please press the <F6> key.
3. The installation will continue. When a message appears to ask you to
designate the device you want to install, press the <S> key.
4. Follow the instruction of the installation program to insert the RAIDExpress 133
ATA RAID Controller Driver diskette into the floppy disk drive then press the
<Enter> key to continue.
5. Select RAIDExpress 133 ATA RAID Controller (Windows 2000/XP) from the
device list shown on the window then press the <Enter> key to continue.
6. The devices that are going to be installed will be listed on the next window.
RAIDExpress 133 ATA RAID Controller (Windows 2000/XP) should be
contained on the list. If you need to install any other devices, please designate
them now. After designating all the devices, please proceed to the next step.
7. Press the <Enter> key to continue the installation of Windows XP.
!