Windows nt – Syba SB-ATA8212-133R User Manual
Page 32
RAIDExpress 133 RAID USER MANUAL
59
3.
If there is a marking ! or ? in front of the RAIDExpress 133 ATA RAID
Controller device as shown below, it indicates that the driver has not been
correctly installed. User should remove the device and reinstall.
RAIDExpress 133 RAID USER MANUAL
60
Windows NT
Install the driver during Windows NT installation
1.
Start Windows NT installation.
Warning: Because of the different selections of the
following installation methods, the time when step2 starts
will be different.
n
Boot from floppy with Windows installation diskette.
n
Boot from floppy with un-installable diskette.
n
Boot from CD-ROM with Windows installation CD.
2.
When the message
“Setup is inspecting your computer’s hardware
configuration
” appears on the bottom of the screen, please press the <F6>
key.
3.
The installation will continue. When a message appears to ask you to
designate the device you want to install, press the <S> key.
4.
The device list of SCSI Adapter will show on the following window. Select
“Other” and press the <Enter> key to continue.
5.
Insert RAIDExpress 133 ATA RAID Controller Driver diskette into the floppy
disk drive then press the <Enter> key to continue.
6.
Select RAIDExpress 133 ATA RAID Controller (Windows NT) from the
device list shown on the window then press the <Enter> key to continue.
7.
The devices that are going to be installed will be listed on the next window.
RAIDExpress 133 ATA RAID Controller (Windows NT) should be contained
on the list. If you need to install any other devices, please designate them now.
After designating all the devices, please proceed to the next step.
8.
Press the <Enter> key to continue the installation of Windows NT.
!